Vehicular Radios
Showing all 61 results
-
VRC-19-QQ
$175.00VRC-19 Radio Set; T278 R394 DY193 CY938
-
BC-603
$195.00BC-603 / SCR-508 superheterodine FM receiver covers 20 to 27.9MHz. The receiver can deliver an output of approximately 2 watts to its self contained speaker or about 200 milliwatts to its headset circuits. The front panel contains 10 push buttons by means of which any one of 10 preadjusted receiving channels may be selected. IF (nominal) 2.65MHZ. Bandwidth 80KHz. Less dynamotor. A couple in stock. Email for photos. 6.8×12.5×11.5 38 lbs sh. Used not tested
-
C-2298-U
$49.50VRC INTERCOMMUNICATION CONTROL used in RT-524/VRC installations with AM-1780 amp; monitors three radios A-B-C. Volume control and two connections for U-229. 5.8×4.5×3.3 4 lbs sh. CARC paint. Picture is not the actual unit. used
-
CV-1377
$65.00SIGNAL DATA TRANSLATOR out of PRC-47. With tubes 5907 7761 7905; Used, for parts only, no couplings . 5 lbs sh.
-
AM-3507
$50.00PRC-47 AMPLIFIER MODULATOR contains LSB 500 KHz mech filter F500-Z5 (#526-9376) plus balanced modulator and product detector. Requires 20 VDC. Module checks bad but the mechanical filter checks good. 4.3×4.5×1.3 1 lb.
-
J-3513A/UN
$40.00VINSON Voice Encryption When the KY-57 is used in a VRC-12 Series installation special Junction Boxes are inserted between the Base mounting and the Tray of the MT-1029 or MT-1898. These junction boxes contain a number of relays and a low power audio amplifier. They are designed to meet TEMPEST requirements. (E2R) Unused.
-
2Z5822-403
$7.00Small bar knob for R-392 and various GRC radios . Top screw mount. o/a .75"L x .75"W x .5"H. (G1Q) Unused
-
PP-282
$50.00PP-282/GRC Internal Power Supply (24 Volt). Input 25.2 volts (20 to 32 volts) 1.23 amperes max. Output 136 volts dc (105 to 185 volts) 0.118 amperes (J1V) Used Vibrators bad. No vibrators available seperate. 5.7×2.9×4.1 7 lbs sh.
-
CRV-7200
$2.00A7200 Module Cover for RT246 only (F3H)
-
CRV-7000
$2.00A7000 Module Cover for RT246 only (F3H)
-
CRV-524
$15.00One each of the following module covers: CRV-3400 CRV-3500 CRV-3600A CRV-4200 CRV-4300 CRV-5100 CRV-8300. (F3H)
-
CRV-8300
$3.00A8300 Module Cover for RT524 / RT246 / R442 (F3H)
-
CRV-5100
$3.00A5100 Module Cover for RT524 / RT246 / R442 (F3H)
-
CRV-4300
$3.00A4300 Module Cover for RT524 / RT246 / R442 (F3H)
-
CRV-4200
$4.00A4200 Module Cover for RT524 / RT246 / R442 (F3H)
-
CRV-3600A
$3.00A3600A Module Cover for RT524 / RT246 / R442 (F3H)
-
CRV-3500
$3.00A3500 Module Cover for RT524 / RT246 / R442 (F3H)
-
CRV-3400
$3.00A3400 Module Cover for RT524 / RT246 / R442 (F3H)
-
CX-4721-10
$24.00CX-4721 10 ft DC power cable connects MT-1029 to MT-1898 mount (P2H) Unused
-
CY3700-PRC-47
$65.00LARGE ALUMINUM TRANSIT CASE with rounded corners hasp fasteners and carrying handles; 21Hx29Wx24D including 6"H top. Spot welded compartments plus two nesting trays; MISSING TWO LATCH PARTS. 66 lbs. sh. (D3O) Used
-
MT-1029-U
$45.00VRC VEHICULAR MOUNT for RT-246 or RT-524/VRC-12 transceivers which were the standard vehicle radios of the U.S. Army. 5×12.5×16 25 lbs. (L2X) Used
-
SCH-PP-3518
$6.00Schematic for PP-3518
-
PP-3518
$45.00POWER SUPPLY is the internal power supply for the PRC-47 transceiver. Power input is 115 v 400 HERTZ . The transformer is also used as part of the DC to DC inverter to power the PRC-47 from 28 VDC. The components of the inverter are on the radio chassis NOT on the power supply chassis and are NOT part of the PP3518. The PP3518 produces -110 vdc PA bias -32 vdc driver bias 1500 vdc 650 vdc + 300 vdc +20 vdc and 6.3 vac for the various circuits of the PRC-47. (Q1Y) 6 lbs sh.
-
O-1032
$24.00RF OSCILLATOR contains 3 MHz crystal in oven; produces 500 and 100 KHz outputs. Requires 20 VDC; 4.3×4.5×1.3 1 lb sh. PRC-47. Used, checked for output not calibrated
-
AM-3507-CON
$7.00Connector set for AM-3507
-
AM-3506
$20.00PRC-47 AUDIO AMP has mic sidetone vox and compressor circuits of TX; AGC & audio for Rx. Requires 20 & 24 VDC. 4.3×4.3×2.8 2 lbs. (M2L)
-
CX-8393
$45.0050 ft AC Cable for PRC-47
-
CX-8396
$19.50"Y" CABLE for H-233 to PRC-47 and other RT Units
-
RT-695-U
$195.00PRC-41 UHF MANPACK TRANSCEIVER 225 to 400 MHz AM in 100 KHz steps. Has guard channel receiver, Volume Squelch and U-77 connection for H-33 handset. Solid-state except for tubes 6442 4/7077 and 4/7544. Requires 24 VDC 3 amps; 14×11.3×4.5 Sh Wt 22 lbs. Used, internally complete, good external condition, for display only.
-
C-435
$23.00C-435/GRC CONTROL plugs into MT-297 mount and allows duplex use and re-transmission of GRC-3 thru 8 radio systems. Meter is the same as on the RT-68 series transmitters. Sh Wt 7 lbs (P2B)
-
C-434-U
$65.00Local Control for GRA-6 system Allows remote control of radio by field phone and wire. Has hand crank generator Maybe G-25 OR G-41 (Q2W) Used
-
MM-VRC-8-9-10
$18.00Maintenance Manual for AN/VRC-8 VRC-9 VRC-10 RT-66 RT-67 RT-68 PP-109 PP-112 PP-281 PP-282 MT-299 repro.
-
CX-1211
$22.00Dogbone interconnect cable RT-66, RT-67, RT-68 to PP-109, PP-112 units (C6P). Cover over wiring between connectors cracked/damaged/missing, wiring intact.
-
RT-68
$150.00TRANSCEIVER 38-54.9 MHz FM used in vehicles from 1950's until Vietnam era FM continuously tunable or 100 KHz-step channels. Receives and transmits both voice and 1600 Hz ringing FM; range 10-15 miles. Receiver circuit has variable 1st IF 4.45-5.45 MHz and fixed 1.4 MHz 2nd IF; also squelch and 600 ohm audio output. Transmitter uses crystal-controlled oscillator and oscillator power amp; power output 2 watts (LO) or 15 W (HI). Also meter to monitor xmiter filaments and 90 V input. Requires PP-109 or PP-112 power supply. Tubes 4/1U4 2E24 2/1A3 2/1L4 4/1R5 2/1AE4 1S5 4/3Q4 3A4 3/3A5 2/3B4 6AK5. 9x13x11.3 42 lbs. (Q2V) Used not tested.
-
Sale!
R-109
$55.50RECEIVER same externally as R-108 27 to 39 MHz FM continuously tuneable variable squelch and audio output impedance 600 ohms. 4.3 MHz. I.F. with tubes 3/1U4 2/1L41A3 2/3A4 1S52/3Q42/6AK5 & 0B2. Voltages req. 135 VDC @ 70 MA. and 6.3 VDC 2 amps. Size: 9x13x7 1/2; wt: 32 lbs. (L2W) Used